Communication
Case Communication Standards Between Clinic and Dental Lab
Most case friction is not technical — it is a communication gap. This is a working standard for describing a case, raising a question and reporting a problem without ambiguity.
Published October 2, 2026
When a case goes wrong, the cause is more often a communication gap than a technical error. The prescription said “A2” and the photograph looked like A3; the occlusion note assumed a centric relation that the record did not capture; the implant system was described by a general family name rather than the specific connection. None of these are failures of skill. They are failures of shared language.
This article is a working standard for how a clinic and its laboratory should communicate, written so it can be adopted as-is or adapted to a specific relationship.
Principle 1: state facts, not conclusions
“There is a problem with the fit” is a conclusion. “The distal margin is open by roughly 0.3 mm, the mesial margin seats fully” is a fact. The fact leads directly to a cause and a remedy; the conclusion leads to a round of questions.
A useful test: could a reader reconstruct what you observed without seeing it? If not, the description is a conclusion rather than a fact.
| Instead of | Write |
|---|---|
| “The crown does not fit properly” | “The unit rocks on the die; the distal margin is open, the mesial seats” |
| “The colour is wrong” | “Body shade reads A3 against the A2 prescription; incisal is correct” |
| “The bite is off” | “Heavy contact on the distobuccal cusp; the patient cannot fully close” |
| “The margin is bad” | “A ledge is visible buccally at the finish line; the interproximal margin is clean” |
Principle 2: name the reference
Any description involving a location needs a reference, or the laboratory is guessing which surface you mean. Use the standard anatomical terms and be specific: mesial, distal, buccal, lingual, occlusal, cervical, incisal. A description that says “the back of the crown” is ambiguous on a molar; “the distal surface” is not.
The same applies to shade: state the shade guide system as well as the shade. A2 in one system is not the same visual target as A2 in another.
Principle 3: write the prescription as the instruction, photographs as context
This is the single most useful rule in the standard. Photographs are extremely valuable — but a camera does not record colour absolutely, and lighting changes the result. When a photograph and the written prescription disagree, the laboratory follows the prescription. The reasoning is covered in full in what a dental lab can and cannot tell from a photo.
The practical consequence: if the photograph is the intended target and the written shade is approximate, say so explicitly. “Written shade is a guide; match the attached photograph taken under daylight” is a clear instruction. Leaving both as equal-weight statements creates an ambiguity the laboratory has to resolve by guessing.
Principle 4: separate the standing instruction from the case instruction
Some preferences apply to every case: contact tightness, margin convention, occlusal scheme, surface texture, packaging, delivery. Some apply only to this case: shade, material, tooth number.
Recording the standing preferences once, at the start of a relationship, removes them from every subsequent case conversation and prevents them being re-litigated. We describe how this works on the team and roles page — standing instructions are recorded against the customer account so every case starts from those standards rather than from a default.
Principle 5: ask early, and answer specifically
Both directions of the exchange benefit from the same discipline:
- Clinic to laboratory. If space is tight, if the shade is a judgement call, if the implant system is uncertain — say so at submission, not after the restoration comes back. A flag at intake is resolved in one message; the same issue discovered at delivery is a remake.
- Laboratory to clinic. A technical question should be specific enough to answer in one reply. “Please confirm the implant system” is answerable. “There is a problem with the case, please advise” is not.
Principle 6: keep everything on the case reference
Case communication should carry an anonymous case reference rather than a patient identifier. This is both a privacy discipline and a practical one: a reference is unambiguous and searchable, whereas a patient name may not be unique and should not be transmitted.
Never send patient names, identifiers or identifiable clinical photographs through routine case channels. The Privacy Policy sets out what we ask you not to send and why.
Principle 7: record the outcome, not just the request
When a question is resolved or a change is agreed, the resolution should be recorded against the case rather than left in a message thread. This is what makes a later review possible: the remake and issue review policy works by comparing the confirmed requirement against what was produced, which requires the confirmed requirement to exist somewhere.
A template for a case submission
A short, consistent structure removes most ambiguity:
Case reference:
Restoration type and tooth number(s):
Material:
Shade (system + shade):
Implant system and connection (implant cases):
Retention method, if applicable:
Occlusal notes:
Space / reduction notes, if marginal:
Special instructions for this case:
Standing preferences to apply: (reference if already on file)
Attachments: files / photos / bite record
Nothing in this template is unusual. Its value is that it is the same every time, so an omission is visible rather than silent.
Why a standard helps both sides
A communication standard is not paperwork. It is the mechanism that lets a laboratory apply judgement where judgement is needed and process where process is needed. When the routine information arrives complete and unambiguous, the technical team spends its attention on the case rather than on reconstructing requirements — which is where the quality difference actually shows up.
Related reading
- What a dental lab can and cannot tell from a photo — how to shoot and interpret case photographs.
- How to reduce dental remakes — the communication causes, alongside the clinical ones.
- Dental lab remake request guide — the specific case of reporting a problem.
- Our team and roles — who handles which question.